Teledyne GFC-7000T - Trace CO2 Analyzer - manual - Manual (Page 150)

Operating Instructions Model GFC7000TA Carbon Dioxide Analyzer
Teledyne Analytical Instruments 132
mA
IN OUT
V OUT +
V OUT -
I IN +
I IN -
Recording
Device
Analyzer
See Table 3-1 for
pin assignments of
the Analog Out
connector on the
rear panel.
Figure 6-12: Setup for Calibrating Current Outputs
NOTE
Do not exceed 60 V between current loop outputs and instrument ground.
To adjust the zero and span values of the current outputs, activate the ANALOG I/O
CONFIGURATION MENU (See Section 6.13.1), then press: