Enable snmp authenticatetrap – Allied Telesis AT-S63 User Manual
Page 116
Chapter 6: SNMPv2 and SNMPv2c Commands
116
Section I: Basic Features
ENABLE SNMP AUTHENTICATETRAP
Syntax
enable snmp authenticatetrap|authenticate_trap
Parameters
None.
Description
This command configures the stack to send authentication failure traps to
trap receivers. The stack sends an authentication failure trap whenever a
SNMP management station attempts to access the stack using an
incorrect or invalid community string, or the management station’s IP
address has not been added to a community string that has a closed
access status.
The default setting for sending authentication failure traps is disabled.
Refer to “ADD SNMP COMMUNITY” on page 104 to enter the IP
addresses of the SNMP trap receivers.
The AUTHENTICATETRAP and AUTHENTICATE_TRAP keywords are
equivalent.
Example
The following command configures the stack to send authentication failure
traps to SNMP trap receivers:
enable snmp authenticatetrap