Allied Telesis AT-S63 - Manual (Page 94)

Chapter 5: Basic Stack Commands
94 Section I: Basic Operations
SHOW CONFIG DYNAMIC
Syntax
show config dynamic[= module ]
Parameters
module Displays the settings of a specific module in the management
software. You can specify only one module at a time. For a list
of modules, refer to Table 2.
Description
This command displays the parameter settings of the stack that have been
changed from their default values, including those not yet saved to the
active boot configuration file. The parameters are displayed in their
command line command equivalents. You can view all of the settings or
limit the display to just those of a particular management software module.
An example of the display is shown in Figure 12.
Figure 12. SHOW CONFIG DYNAMIC Command
The MODULE variable limits the display to a particular management
software module. You can specify only one module per command. The
modules are listed in Table 2.
---Start of current configuration ------------------
#
# System Configuration
#
set system name="Production Stack"
set system contact="Jane Smith"
set system location="Bldg. 2, room 411"
#
# User Authentication Configuration
#
Table 2. Module Variable
Variable Description
ARP Static ARP entries
EVTLOG Event log and syslog client
INTF Routing interface