Set lacp syspriority – Allied Telesis AT-S63 User Manual
Page 186
Advertising
Chapter 11: LACP Port Trunking Commands
186
Section I: Basic Operations
SET LACP SYSPRIORITY
Syntax
set lacp syspriority=0x
priority
Parameters
syspriority
Specifies the LACP system priority value for a switch.
This is a hexadecimal value from 0x1 to 0xffff. The
lower the number, the higher the priority. The default is
0x0080.
Description
This command sets the LACP priority of the switch. LACP uses the priority
to resolve conflicts between two switches to decide which switch makes
the decision about which ports to aggregate.
Example
The following command sets the LACP priority on the switch to 0x8000:
set lacp syspriority=0x8000
Advertising