Allied Telesis AT-S63 - Manual (Page 436)

Chapter 23: 802.1x Port-based Network Access Control Commands
436 Section VIII: Port Security
startperiod Specifies the time period in seconds between
successive attempts by the supplicant to establish
contact with an authenticator when there is no reply.
The range is 1 to 60. The default is 30.
username or Specifies the username for the switch port. The
name parameters are equivalent. The port sends the name to
the authentication server for verification when the port
logs on to the network. The username can be from 1 to
16 alphanumeric characters (A to Z, a to z, 1 to 9). Do
not use spaces or special characters, such as asterisks
or exclamation points. The username is case-sensitive.
password Specifies the password for the switch port. The port
sends the password to the authentication server for
verification when the port logs on to the network. The
password can be from 1 to 16 alphanumeric characters
(A to Z, a to z, 1 to 9). Do not use spaces or special
characters, such as asterisks or exclamation points.
The password is case-sensitive.
Description
This command sets ports to the supplicant role and configures the
supplicant role parameters. This command also removes port-based
access control on a port.
Examples
The following command sets ports 5.14 to 5.16 to the supplicant role:
set portacess port=5.14-5.16 role=supplicant
The following command sets port 2.8 to the supplicant role, the name to
“switch22,” and the password to “bluebird”:
set portaccess port=2.8 role=supplicant name=switch22
password=bluebird
The following command removes port-based access control on ports 1.12
and 2.15:
set portaccess port=1.12,2.15 role=none