Allied Telesis AT-S63 - Manual (Page 99)

AT-S63 Stack Command Line User’s Guide
Section I: Basic Operations 99
information correctly. When OFF, the default setting, no NULL
character is set after a CR. To set this feature, see “SET TELNET
INSERTNULL” on page 90.
ˆ MAC address aging time - The current value for the MAC address
aging timer. The switch uses the aging timer to delete inactive dynamic
MAC addresses from the MAC address table. To set this value, refer to
“SET SWITCH AGINGTIMER|AGEINGTIMER” on page 157.
ˆ Console startup mode - The management interface —menus or
command line — that initially appears at the start of a local or remote
management session. The default is the command line interface. This
cannot be changed on a stack, because a stack must be configured
from the command line interface.
ˆ Multicast Mode - The multicast mode, which determines the behavior
of the stack when forwarding ingress spanning tree BPDU packets and
802.1x port-based access control EAPOL packets To set the multicast
mode, refer to “SET SWITCH MULTICASTMODE” on page 353.
Example
This command displays information about the master switch:
show switch module=1