Allied Telesis AT-S63 - Manual (Page 66)

Chapter 3: Basic Command Line Commands
66 Section I: Basic Operations
SAVE CONFIGURATION
Syntax
save configuration
Parameters
None.
Description
This command saves your changes to the parameter settings of the stack
in the master switch’s active boot configuration file for permanent storage.
Changes to the operating parameters of a stack, such as the creation of a
new virtual LAN or static port trunk, are initially stored in temporary
memory, where they will be lost the next time the stack is reset or power
cycle.
To permanently save your changes, you must use this command. It saves
your changes as a series of commands in the active boot configuration file
on the master switch. The master switch uses the file whenever you reset
or power cycle the stack to recreate the settings.
To view the name of the active boot configuration file, see “SHOW
CONFIG” on page 212. To view the contents of a configuration file, see
“SHOW FILE” on page 213.
Example
save configuration