Allied Telesis AT-S63 - Manual (Page 160)

Chapter 9: MAC Address Table Commands
160 Section I: Basic Operations
Note
You can specify more than one parameter at a time with this
command.
Description
This command displays the unicast and multicast MAC addresses learned
or assigned to the ports on the stack and stored in the stack’s MAC
address table. Figure 17 is an example.
Figure 17. SHOW SWITCH FDB Command - Unicast Addresses
Note
The first address in the unicast MAC address table is the address of
the master switch of the stack.
The columns are defined here:
ˆ VLAN ID - The ID number of the VLAN where the port is an untagged
member.
ˆ MAC - The dynamic or static unicast MAC address learned on or
assigned to the port.
ˆ Port - The port where the address was learned or assigned. The MAC
address of port 1.0 is the switch’s address.
ˆ Status - The type of address: static or dynamic.
Switch Forwarding Database
Total Number of MAC Addresses: 121
VLAN ID MAC Address Port Status
------------------------------------------------------------
0
01:80:C1:00:02:01 1.0 Static (fixed, non-aging)
1 00:a0:d2:18:1a:c8 1.1 Dynamic
1 00:a0:c4:16:3b:80 1.2 Dynamic
1 00:a0:12:c2:10:c6 1.3 Dynamic
1 00:a0:c2:09:10:d8 1.4 Dynamic
1 00:a0:33:43:a1:87 1.4 Dynamic
1 00:a0:12:a7:14:68 1.4 Dynamic
1 00:a0:d2:22:15:10 1.4 Dynamic
1 00:a0:d4:18:a6:89 1.4 Dynamic