Allied Telesis AT-S63 - Manual (Page 235)

235
Chapter 15
Event Log and Syslog Client Commands
This chapter contains the following commands:
ˆ “ADD LOG OUTPUT” on page 236
ˆ “CREATE LOG OUTPUT” on page 238
ˆ “DESTROY LOG OUTPUT” on page 242
ˆ “DISABLE LOG” on page 243
ˆ “DISABLE LOG OUTPUT” on page 244
ˆ “ENABLE LOG” on page 245
ˆ “ENABLE LOG OUTPUT” on page 246
ˆ “PURGE LOG” on page 247
ˆ “SAVE LOG” on page 248
ˆ “SET LOG FULLACTION” on page 250
ˆ “SET LOG OUTPUT” on page 251
ˆ “SHOW LOG” on page 254
ˆ “SHOW LOG OUTPUT” on page 259
ˆ “SHOW LOG STATUS” on page 261
Note
Remember to save your changes with the SAVE CONFIGURATION
command.
Note
The event logs on the master switch are the only active logs in the
stack. The event logs on the member switches are inactive. For
background information about event logs and the syslog client, refer
to the AT-S63 Management Software Features Guide.