Allied Telesis AT-S63 - Manual (Page 53)

AT-S63 Stack Command Line User’s Guide
Section I: Basic Operations 53
ˆ Stop bits: 1
ˆ Flow control: None
Note
The port settings are for a DEC VT100 or ANSI terminal, or an
equivalent terminal emulator program.
5. Press Enter.
You are prompted for a user name and password.
6. Enter a user name and password. The stack comes with two standard
user accounts: manager and operator. The manager account lets you
configure the stack’s settings while the operator account only lets you
view them.
To log in as the manager, enter “manager” as the user name. The
default password for manager access is “friend. “To log in as an
operator, enter “operator” as the user name. The default password for
operator access is “operator.” User names and passwords are case
sensitive.
Note
A stack can support one manager session and eight operator
sessions simultaneously.
7. The local management session starts and the command line interface
(CLI) prompt is displayed, as shown in Figure 8. If the stack has a
name, the name appears below the master switch’s model name.
Figure 8. CLI Prompt
8. You can now begin to manage the stack with the commands described
in this guide.
Allied Telesis AT-9424T/GB - AT-S63
<No System Name>
#