Allied Telesis AT-S63 - Manual (Page 343)

343
Chapter 19
Spanning Tree Protocol Commands
This chapter contains the following commands:
ˆ “ACTIVATE STP” on page 344
ˆ “DISABLE STP” on page 345
ˆ “ENABLE STP” on page 346
ˆ “PURGE STP” on page 347
ˆ “SET STP” on page 348
ˆ “SET STP PORT” on page 351
ˆ “SET SWITCH MULTICASTMODE” on page 353
ˆ “SHOW STP” on page 355
Note
Remember to save your changes with the SAVE CONFIGURATION
command.
Note
For overview information on the spanning tree protocol (STP), refer
to the AT-S63 Management Software Features Guide.