Set switch mirror – Allied Telesis AT-S63 User Manual
Page 193
AT-S63 Stack Command Line User’s Guide
Section I: Basic Operations
193
SET SWITCH MIRROR
Syntax
set switch mirror=
port
Parameter
mirror
Specifies the destination port for the port mirror, where
the traffic from the source ports is copied. A stack can
have only one destination port. To stop port mirroring
and free the destination port for use as a normal
networking port, specifying “0” (zero) as the destination
port. Port numbers are specified in the following format:
module ID.port number
For instructions, refer to “Port Numbers in Commands”
on page 42.
Description
This command enables mirroring and specifies the destination port, or
stops port mirroring. To select the source ports, refer to “SET SWITCH
PORT MIRROR” on page 194.
Examples
This command activates mirroring and designates port 2.11 as the
destination port:
set switch mirror=2.11
This command stops port mirroring:
set switch mirror=0