Disable lacp – Allied Telesis AT-S63 User Manual
Page 182
Advertising
Chapter 11: LACP Port Trunking Commands
182
Section I: Basic Operations
DISABLE LACP
Syntax
disable lacp
Parameters
None.
Description
This command disables LACP on the switch. The default is disabled.
Caution
Do not disable LACP if there are defined aggregators without first
disconnecting all cables connected to the aggregate trunk ports.
Otherwise, a network loop may occur, resulting in a broadcast storm
and poor network performance.
Example
The following command disables LACP on the switch:
disable lacp
Equivalent Command
set lacp state=disable
For information, see “SET LACP STATE” on page 187.
Advertising