Allied Telesis AT-S63 - Manual (Page 130)

Chapter 7: Port Parameter Commands
130 Section I: Basic Operations
SET SWITCH PORT
Syntax
set switch port= port [description=” description ”]
[status=enabled|disabled]
[speed=autonegotiate|10mhalf|10mfull|100mhalf|100mfull|
1000mfull]
[mdimode=mdi|mdix|auto]
[flowcontrol=disable|enable|auto]
[fctrllimit=
value ]
[backpressure=yes|no|on|off|true|false|enabled|
disabled]
[bplimit=
value ]
[holbplimit= value ]
[renegotiation=auto]
[softreset]
Parameters
port Specifies the port to be configured. You can
configure more than one port at a time. Port
numbers are specified in the following format:
module ID.port number
For instructions, refer to “Port Numbers in
Commands” on page 42.
description Specifies a description of up to 15 alphanumeric
characters for the port. Spaces are allowed but
not special characters. A name with spaces
must be enclosed in double quotes. Otherwise,
the quotes are optional. You cannot specify a
description if you are configuring more that one
port.
status Specifies the operating status of the port. The
options are:
enabled The port forwards network traffic.
This is the default setting.
disabled The port does not forward network
traffic.
speed Sets the speed and duplex mode of the port.
The options are:
autonegotiate The port uses Auto-Negotiation
for both speed and duplex mode.
This is the default setting.