Allied Telesis AT-S63 - Manual (Page 435)

AT-S63 Stack Command Line User’s Guide
Section VIII: Port Security 435
SET PORTACCESS|PORTAUTH PORT ROLE=SUPPLICANT
Syntax
set portaccess|portauth port= port type|role=supplicant|none
[authperiod= value ] [heldperiod= value ] [maxstart= value ]
[startperiod= value ] [username|name= name ]
[password= password ]
Note
The PORTACCESS and PORTAUTH keywords are equivalent.
Parameters
port Specifies the port that you want to set to the supplicant
role or whose supplicant settings you want to adjust.
You can specify more than one port at a time. Port
numbers are specified in the following format:
module ID.port number
For instructions, refer to “Port Numbers in Commands”
on page 42.
type or Specifies the role of the port. The parameters are
role equivalent. The options are:
supplicant Specifies the supplicant role.
none Disables port-based access control on
the port.
authperiod Specifies the period of time in seconds that the
supplicant will wait for a reply from the authenticator
after sending an EAP-Response frame. The range is 1
to 300 seconds. The default is 30 seconds.
heldperiod Specifies the amount of time in seconds the supplicant
is to refrain from retrying to re-contact the authenticator
in the event the end user provides an invalid username
and/or password. After the time period has expired, the
supplicant can attempt to log on again. The range is 0
to 65,535. The default value is 60.
maxstart Specifies the maximum number of times the supplicant
will send EAPOL-Start frames before assuming that
there is no authenticator present. The range is 1 to 10.
The default is 3.