Allied Telesis AT-S63 - Manual (Page 336)

Chapter 18: SNMPv3 Commands
336 Section IV: SNMPv3
SHOW SNMPV3 TARGETADDR
Syntax
show snmpv3 targetaddr= targetaddr
Parameter
targetaddr Specifies an SNMPv3 Target Address Table entry.
Description
This command displays SNMPv3 Target Address Table entries. You can
display one or all of the table entries.
Examples
The following command displays the SNMPv3 Target Address Table entry
called “snmpv3host55”:
show snmpv3 targetaddr=snmpv3host55
The following command displays all of the SNMPv3 Target Address Table
entries:
show snmpv3 targetaddr