Disable log – Allied Telesis AT-S63 User Manual
Page 243
Advertising
AT-S63 Stack Command Line User’s Guide
Section II: Advanced Operations
243
DISABLE LOG
Syntax
disable log
Parameters
None.
Description
This command disables the event log module. When the log module is
disabled, the AT-S63 Management Software stops storing events in the
event logs and sending events to output definitions. The default setting for
the event logs is enabled.
Note
The event log module, even when disabled, still logs all AT-S63
initialization events that occur when the stack is reset or power
cycled. Any events that occur after AT-S63 initialization are recorded
only if the event log module is enabled.
Examples
The following command disables the event log on the switch:
disable log
Advertising