Purge snmpv3 view – Allied Telesis AT-S63 User Manual
Page 315
Advertising
AT-S63 Stack Command Line User’s Guide
Section IV: SNMPv3
315
PURGE SNMPV3 VIEW
Syntax
purge snmpv3 view
Parameters
None
Description
This command resets the SNMPv3 View Table to its default values by
removing all the view table entries. To remove a single entry, use
“DESTROY SNMPV3 VIEW” on page 310.
Example
The following example removes all the entries from the SNMPv3 View
Table:
purge snmpv3 view
Advertising