Create switch trunk – Allied Telesis AT-S63 User Manual
Page 168
Chapter 10: Static Port Trunking Commands
168
Section I: Basic Operations
CREATE SWITCH TRUNK
Syntax
create switch trunk=
name
port=
ports
[select=macsrc|macdest|macboth|ipsrc|ipdest|ipboth]
Parameters
trunk
Specifies the name of the trunk. The name can be up to
16 alphanumeric characters. No spaces or special
characters are allowed.
port
Specifies the ports to be added to the port trunk. Port
numbers are specified in the following format:
module ID.port number
For instructions, refer to “Port Numbers in Commands”
on page 42.
select
Specifies the load distribution method. Options are:
macsrc
Source MAC address.
macdest
Destination MAC address.
macboth
Source address/destination MAC
address.
ipsrc
Source IP address.
ipdest
Destination IP address.
ipboth
Source address/destination IP
address.
Description
This command creates a static port trunk. To create the trunk, you specify
the stack ports and the load distribution method. For an explanation of the
load distribution methods, refer to the AT-S63 Management Software
Features Guide.