Allied Telesis AT-S63 - Manual (Page 264)

Chapter 16: Class of Service (CoS) Commands
264 Section II: Advanced Operations
SET SWITCH PORT PRIORITY OVERRIDEPRIORITY
Syntax
set switch port= port [priority= value ]
[overridepriority=yes|no|on|off|true|false]
Parameters
port Specifies the port to be configured. You can
specify more than one port at a time, but the
ports must be of the same medium type (either
all twisted pair ports or all fiber optic ports). Port
numbers are specified in the following format:
module ID.port number
For instructions, refer to “Port Numbers in
Commands” on page 42.
priority Specifies a temporary priority level for all
ingress untagged packets received on the port.
If you include the OVERRIDEPRIORITY
parameter, the temporary priority level also
applies to all ingress tagged packets. The range
is 0 to 7; 0 is the lowest priority, and 7 is the
highest.
overridepriority Determines if a port should ignore the priority
level in tagged packets and instead use the
temporary priority level assigned to the port with
the PRIORITY parameter. The options are:
yes, on, true Overrides the priority level in
tagged packets and uses the
temporary priority level. This is
the default. The options are
equivalent.
no, off, false Does not override the priority in
tagged packets. The options are
equivalent.
Description
This command can change a port’s temporary priority level. It can also be
used to determine whether a port receiving tagged packets should use the
priority level in the frames or a temporary priority level assigned to the
port.