Allied Telesis AT-S63 - Manual (Page 201)

AT-S63 Stack Command Line User’s Guide
Section II: Advanced Operations 201
COPY
Syntax
copy [cflash:] sourcefile.ext [cflash:] destinationfile.ext
Parameters
sourcefile.ext Specifies the name of the source file. If the file is
stored on a compact memory flash card, precede
the name with “cflash:”. If the filename contains
spaces, enclose it in double quotes. Otherwise, the
quotes are optional.
destinationfile.ext Specifies the name of the destination file. To store
the copy on a compact memory flash card, precede
the name with “cflash:”. If the filename contains
spaces, enclose it in double quotes.
Description
This command creates a copy of an existing file in the file system of the
master switch. It also copies files between the master switch’s file system
and a compact flash memory card, for those switches that support the
card.
Note the following before using this command:
ˆ This command does not accept a directory path. When copying a file to
or from a compact flash card, you must first change to the appropriate
directory on the card. For instructions, refer to “SET CFLASH DIR” on
page 208. The default location is the root of the flash card.
ˆ Files with the extension UKF are encryption key pairs. These files
cannot be copied, renamed, or deleted from the file system.
ˆ The new filename must be a valid filename from 1 to 16 alphanumeric
characters. The name of the copy must be unique from the other files
in the file system.
ˆ ext is the three-letter file extension, and can be any of the types listed
in Table 3. You must give the copy the same extension as the original
file.
Table 3. File Extensions and File Types
Extension File Type
.cfg Configuration file
.cer Certificate file