Purge snmpv3 targetaddr – Allied Telesis AT-S63 User Manual
Page 314
Advertising
Chapter 18: SNMPv3 Commands
314
Section IV: SNMPv3
PURGE SNMPV3 TARGETADDR
Syntax
purge snmpv3 targetaddr
Parameters
None
Description
This command resets the SNMPv3 Target Address Table to its default
values by removing all the target address table entries. To remove a single
entry, use “DESTROY SNMPv3 TARGETADDR” on page 308.
Example
The following example removes all the entries from the SNMPv3 Target
Address Table:
purge snmpv3 targetaddr
Advertising