Allied Telesis AT-S63 - Manual (Page 147)

AT-S63 Stack Command Line User’s Guide
Section I: Basic Operations 147
SHOW SWITCH MODULE COUNTER
Syntax
show switch module= id counter
Parameters
id Specifies the ID number of a switch in the stack.
You can specify only one switch at a time. To
view the ID numbers of the switches, refer to
“SHOW STACK” on page 72.
Description
This command displays the operating statistics, such as the number of
ingress and egress packets, of a switch in a stack. An example is shown in
Figure 15.
Figure 15. SHOW SWITCH COUNTER Command
The command provides the following information:
Bytes Rx
Number of bytes received by the switch.
Bytes Tx
Number of bytes transmitted by the switch.
Frames Rx
Number of frames received by the switch.
Frames Tx
Number of frames transmitted by the switch.
Module: 2 Port: All
Bytes Rx ......... 983409801 Bytes Tx ......... 965734443
Frames Rx ........ 815423 Frames Tx ........ 691396
Bcast Frames Rx... 107774 Bcast Frames Tx .. 1853
Mcast Frames Rx .. 11429 Mcast Frames Tx .. 0
Frames 64 ........ 110509 Frames 65-127 .... 15192
Frames 128-255 ... 1928 Frames 256-511 ... 442
Frames 512-1023 .. 157796 Frames 1024-1518.. 1221024
CRC Error ........ 0 Jabber ........... 0
No. of Rx Errors . 0 No. of Tx Errors . 0
UnderSize Frames . 0 OverSize Frames .. 0
Fragments ........ 0 Collision ........ 0
Frames 1519-1522 . 0 Dropped Frames ... 0