Allied Telesis AT-S63 User Manual
Page 133
AT-S63 Stack Command Line User’s Guide
Section I: Basic Operations
133
The following command sets the speed on ports 1.2 to 1.6 to 100 Mbps,
the duplex mode to full duplex, the wiring configuration to MDI-X, and flow
control to enabled:
set switch port=1.2-1.6 speed=100mfull mdimode=mdix
flowcontrol=enabled
The following command resets port 5.5:
set switch port=5.5 softreset
Equivalent Commands
disable switch port=
port
For information, see “DISABLE SWITCH PORT” on page 124.
disable switch port=
port
flow=pause
For information, see “DISABLE SWITCH PORT FLOW” on page 125.
enable switch port=
port
For information, see “ENABLE SWITCH PORT” on page 126.
enable switch port=
port
flow=pause
For information, see “ENABLE SWITCH PORT FLOW” on page 127.
reset switch port=
port
For information, see “RESET SWITCH PORT” on page 129.