Allied Telesis AT-S63 - Manual (Page 261)

AT-S63 Stack Command Line User’s Guide
Section II: Advanced Operations 261
SHOW LOG STATUS
Syntax
show log status
Parameter
None.
Description
This command displays information about the event log feature. Figure 30
is an example of the information displayed by this command.
Figure 30. SHOW LOG STATUS Command
The Event Logging field indicates whether the feature is enabled or
disabled. If enabled, the stack stores events in the event logs and sends
events to defined outputs. If disabled, no events are stored in the event
logs or sent to defined outputs. To enable and disable the event logs, refer
to “ENABLE LOG” on page 245 and “DISABLE LOG” on page 243.
The Number of Output Definitions is the sum of the two event logs plus
any output definitions that you might have created. For instance, the
number 4 for Number of Output Definitions in the above example indicates
the existence of two output definitions in addition to the two event logs. To
create new output definitions, refer to “CREATE LOG OUTPUT” on
page 238 and “ADD LOG OUTPUT” on page 236.
Example
The following command displays event log status information:
show log status
Event Log Configuration:
Event Logging .................... Enabled
Number of Output Definitions ..... 4