Allied Telesis AT-S63 - Manual (Page 118)

Chapter 6: SNMPv2 and SNMPv2c Commands
118 Section I: Basic Features
SET SNMP COMMUNITY
Syntax
set snmp community=" community " [access=read|write]
[open=yes|no|on|off|true|false]
Parameters
community Specifies the SNMP community string whose access
level or access status is to be changed. This community
string must already exist on the stack. This parameter is
case sensitive. The name must be enclosed in double
quotes if it contains a space or other special character
such as an exclamation point. Otherwise, the quotes
are optional.
access Specifies the new access level. Options are “read” for
read only access and “write” for both read and write
access. If no access level is specified, the default is
“read.”
open Specifies the open or closed access status of the
community string. The options are:
yes, on, true The community string is open,
meaning that any management station
can use the string to access the stack.
These options are equivalent.
no, off, false The community string is closed,
meaning that only those management
stations whose IP addresses are
assigned to the string can use it to
access the stack. To add IP addresses
of management stations to a
community string, refer to “ADD SNMP
COMMUNITY” on page 104. The
default setting for a community string is
closed. These options are equivalent.
Description
This command changes the access level and access status of an existing
SNMP community string.