Allied Telesis AT-S63 - Manual (Page 159)

AT-S63 Stack Command Line User’s Guide
Section I: Basic Operations 159
SHOW SWITCH FDB
Syntax
show switch fdb [macaddress|destaddress= macaddress ]
[port= port ] [type|status=static|staticunicast|
staticmulticast|dynamic|dynamicunicast|dynamicmulticast]
[vlan=
name ]
Parameters
address Specifies a MAC address. Use this parameter to determine
the port on the stack where a particular MAC address was
learned (dynamic) or assigned (static). The address can be
entered in either of the following formats:
xxxxxxxxxxxx or xx:xx:xx:xx:xx:xx
port Specifies a port on the stack. Use this parameter to view all
addresses learned on a particular port. You can specify more
than one port. Port numbers are specified in the following
format:
module ID.port number
For instructions, refer to “Port Numbers in Commands” on
page 42.
type or Displays specific types of MAC addresses. Options are:
status
static Displays all static unicast and multicast
MAC addresses.
staticunicast Displays all static unicast addresses.
staticmulticast Displays all static multicast addresses.
dynamic Displays all dynamic unicast and
multicast MAC addresses.
dynamicunicast Displays all dynamic unicast addresses.
dynamicmulticast Displays all dynamic multicast
addresses.
vlan Specifies a VLAN name. Use this parameter to view the MAC
addresses learned or assigned to the ports of a particular
VLAN on the stack.