Allied Telesis AT-S63 - Manual (Page 89)

AT-S63 Stack Command Line User’s Guide
Section I: Basic Operations 89
SET SYSTEM
Syntax
set system [name=" name "] [contact=" contact "]
[location=" location "]
Parameters
name Specifies the name of the stack. The name can be from 1 to
39 alphanumeric characters in length and must be enclosed
in double quotes (“ “). Spaces are allowed.
contact Specifies the name of the network administrator responsible
for managing the stack. The contact can be from 1 to 39
alphanumeric characters in length and must be enclosed in
double quotes. Spaces are allowed.
location Specifies the location of the stack. The location can be from 1
to 39 alphanumeric characters in length and must be
enclosed in double quotes. Spaces are allowed.
Description
This command sets a stack’s name, the name of the network administrator
responsible for managing it, and the location of the devices. If a parameter
already has a value, the new value replaces the existing value. To view the
current values for these parameters, refer to “SHOW SYSTEM” on
page 100. To delete a value without assigning a new value, refer to
“RESET SYSTEM” on page 80.
Note
If you define the system name before you set up a system prompt,
the master switch uses the first 16 characters of the system name as
the prompt. See “SET PROMPT” on page 67.
Examples
The following command sets a stack’s information:
set system name="Sales" contact="Jane Smith" location="Bldg
3, rm 212"
The following command sets just the stack’s name:
set system name="PR Office"