Anritsu ML2430A - Manual (Page 103)

Related
Commands: *RCL
*SRE Setup service request enable register GPIB 488.2
Syntax: *SRE <val>
val: 8-bit mask
Remarks: Sets the Service request enable register bits.
*SRE? Return Service Request Enable register GPIB 488.2
Syntax: *SRE?
Remarks: Returns the Service Request Enable register.
*STB? Return Status Byte register GPIB 488.2
Syntax: *STB?
Remarks: Returns the status byte value with bit 6 replaced with the MSS value. MSS
is the GPIB Master Summary Status, and indicates that the device has at
least one reason for requesting service. Although the MSS message is
sent in bit position 6 of the device’s response to the *STB? query, it is not
sent in response to a serial poll and should not be considered part of the
IEEE 488.1/2 status byte. MSS = the Status Byte (STB) OR`ed with the
Service Request Enable register (SRE). Unlike the *ESR? Command, this
command does not clear the register afterwards.
*TRG Perform the GPIB 'Group Execute Trigger' command GPIB 488.2
Syntax: *TRG
Remarks: Performs a 'GET' command. The GT0, GT1 and GT2 commands set the
response to the GET or *TRG commands. When the ML2430 Series is
triggered using this command or the 488.1 hardware trigger, a trigger and
output for each display channel that is not OFF gives a response in the
output queue. If both display channels are displayed, there will be two
messages in the output queue to be read out.
Related
Commands: GT0, GT1, GT2
6-16 ML2430A OM
ML24XXA NATIVE COMMANDS GPIB OPERATION