Anritsu ML2430A - Manual (Page 57)

Print
[PRINT]
This selection prints the screen and various operational settings through the rear
panel printer port.
Battery Controls battery setup when the optional battery pack is installed.
AUTO
[BAUTS] Enables or disables the automatic power off feature. Automatic
power off can be used to conserve battery power when operating
from the internal battery.
TIME
[BAUTT] When operating from the internal battery, Time sets the number of
minutes that the instrument will run before powering off in absence
of any key activity. Enter a value of 10 to 240 minutes.
STATUS Displays the installed battery type, remaining capacity (%), esti-
mated operating time remaining (minutes), and the battery’s full
charge capacity (mAh).
ML2430A OM 4-29
OPERATION SYSTEM MENU
ANRITSU Power Meter ML2437A s/n: 97180010
Firmware: 2.02
Sensor A: NOT FITTED
Sensor Measurement Setup
Measurement Channel Setup
Readout
Measurement mode
Cal factor
Averaging mode & number
Low level averaging
Offset type & value
Settle % per reading
Range hold
Sensor zeroed
Trigger source
Trigger sample delay
Trigger gate width
Trigger arm
Measured value
High limit
Low limit
Limits test
A:
Default
Frequency (50.00MHz)
Auto
Low
Off
0.10%
Off
No
1: (A) 2: OFF
1:
Continuous
1.00ms
20.00ms
Blanking OFF
------
Off
Off
Off
Figure 4-7. Sample ML2430A Series Printout