Anritsu ML2430A - Manual (Page 110)

Manual uses the CFCAL number itself.
VGHz takes the frequency from the V/GHz input and uses it to look up the
calibration factor from the EEPROM in the sensor.
Related
Commands: CFVAL
Query: CFSRC? <s>
Returned
String: CFSRC <s>,<source>
CFUADD Add an entry pair to a cal factor table SENSOR
Syntax: CFUADD <s>,<table number>,<frequency value>[units],
<cal factor>,<cal factor units>
s: A or B
table
number: 1 to number of tables supported by the sensor type
frequency
value: 10 kHz to 122 GHz
cal factor: 0.07 to 150%
31.55 to –1.76 dB
cal factor
units: %, PCT, DB, or DBM
Remarks: Adds an entry pair to a cal factor table. This only affects the copy of the cal
factor table stored in the memory of the power meter. Cal factors entered
with this command will be available for use by the DSP, but will NOT be
saved to the sensor until a save command (
CFUSAV) is executed. If the
sensor is changed or power is lost before saving, all changes made since
the last
CFUSAV will be lost.
The user must ensure that the maximum number of cal factor data pairs
entered into a table is not exceeded. Sensors with a maximum frequency
of up to 40 GHz will hold 90 pairs, while sensors with a maximum fre-
quency of 50 GHz will hold 110 pairs.
Related
Commands: CFUSAV
CFUCT Clear cal factor table SENSOR
Syntax: CFUCT <s>,<table number>
s: A or B
table
number: 1 to number of tables supported by the sensor type
ML2430A OM 6-23
GPIB OPERATION ML24XXA NATIVE COMMANDS