Anritsu ML2430A - Manual (Page 189)

*RST Reset Device
Syntax: *RST
Remarks: Resets the ML2430A Series to the default configuration (see Appendix A,
Section A-3, or see the HP manual when in HP 437B emulation mode).
Offset tables are not cleared. The GPIB ADDRess and EMULation settings
are not changed, and the input queue, output queue, and status registers
on the GPIB are not cleared. This command produces the same result as
the front panel key sequence
System|Setup|PRESET|RESET.
*SRE Setup service request enable register
Syntax: *SRE <val>
val: 8-bit mask
Remarks: Sets the Service request enable register bits.
*SRE? Return Service Request Enable register
Syntax: *SRE?
Remarks: Returns the Service Request Enable register.
*STB? Return Status Byte register
Syntax: *STB?
Remarks: Returns the status byte value with bit 6 replaced with the MSS value. MSS
is the GPIB Master Summary Status, and indicates that the device has at
least one reason for requesting service. Although the MSS message is
sent in bit position 6 of the device’s response to the *STB? query, it is not
sent in response to a serial poll and should not be considered part of the
IEEE 488.1/2 status byte. MSS = the Status Byte (STB) OR`ed with the
Service Request Enable register (SRE). Unlike the *ESR? Command, this
command does not clear the register afterwards.
*TST? Self Test
Syntax: *TST?
6-102 ML2430A OM
HP 437B EMULATION COMMANDS GPIB OPERATION