Anritsu ML2430A - Manual (Page 192)

DE display enable
Syntax: DE
Remarks: Return the display to normal operation after the display has been set in DD
mode.
Related
Commands: DD, DF
DF Display disable
Syntax: DF
Remarks: Turns the display off to allow faster measurements to be taken.
Related
Commands: DD, DE
DR Set GPIB address
Syntax: DR<val><terminator>
val: 1 to 30
terminator: EN
Remarks: Changes the device address. The power meter default address is 13.
DY Duty Cycle
Syntax: DY<val><terminator>
val: duty cycle value in percent
terminator: %, PCT, or EN
Remarks: Sets the duty cycle to be applied to the input signal.
EMUL GPIB emulation mode
Syntax: EMUL <mode>
mode: ML24XX (Anritsu ML2430A Series native mode)
HP436A (Hewlett-Packard)
HP437B (Hewlett-Packard)
ML2430A OM 6-105
GPIB OPERATION HP 437B EMULATION COMMANDS