Lull 944E-42 Service Manual - Manual (Page 109)

4.5 Model 644E-42/944E-42 Rev. 6/04
Cab and Covers
b. Seat Installation
Note: ALWAYS replace elastic locknuts with new elastic
locknuts to help ensure proper fastening.
1. Position the seat (4) on the seat riser (10). Align the
studs on the seat with the mounting holes (17) in the
seat riser. Secure the seat to the riser with four flat
washers (12) and new elastic locknuts (11). Torque
nuts to 20 lb-ft (27 Nm).
2. Fasten the tethers (6) to the seat riser (10) using
capscrews (7), spacers (9) and flat washers (8).
4.3.2 Steering Wheel, Transmission Travel
and Gear Select Lever and Turn Signal
Select Lever
The steering wheel, transmission travel and gear select
lever and optional turn signal select lever are mounted on
the steering column.
a. Steering Wheel Removal
1. Park the vehicle on a firm, level surface. Level the
vehicle, ground the attachment, place the travel
select lever in the (N) NEUTRAL DETENT position,
engage the parking brake switch and shut the
engine OFF.
2. Carefully pry the horn button (18) out of its recess in
the steering wheel. Disconnect the horn switch
lead (19).
3. Mark the steering wheel and shaft to ensure proper
installation. Remove the nut (20) securing the steering
wheel (21) to the splined steering column shaft.
4. Use a steering wheel puller to remove the steering
wheel (21) from the splined shaft.
b. Steering Wheel Installation
1. Install the steering wheel (21) onto the splined
steering column shaft.
2. Secure the steering wheel with a nut (20). Torque
the nut to 50 lb-ft (68 Nm).
3. Connect the horn switch lead (19), then press the
horn button (18) into the recess in the steering wheel.
MU1260
18
19
20
21