Lull 944E-42 Service Manual - Manual (Page 718)

Electrical System
9.208 Model 644E-42/944E-42 Rev. 6/04
e. Installation and Testing
1. Check that the variable speed fan control (1) is in the
OFF position.
2. If installing the temperature control (2) attach the
control cable (not shown) to the back of the control.
3. Insert the control shaft (1 or 2) through the control
panel (3), ensuring that the knob will in the vertical
position when installed on the shaft.
4. Install the hex locknut on the shaft and tighten.
5. Connect the cab harness connector to the variable
speed fan control.
6. Install the knob (1 or 2) and tighten setscrew,
securing the knob to the control.
7. Snap air conditioning rocker switch (4) into mounting
hole on the control panel. Connect cab harness
connector to the back of the rocker switch.
8. Install the screws (5) and backing locknuts, securing
the control panel to the dash panel.
9. If the vehicle has dual batteries, connect both
negative battery cables (6 and 7) to both batteries.
Connect the lower negative battery cable (6) to the
negative (-) terminal on the lower battery (8). Swing
the upper battery box (9) in and make sure that the
lip (10) on the upper battery box slides below the
knob (11). Secure in place with the knob.
10. Turn the ignition switch (14) into the START (17)
position and start the vehicle. Allow the ignition
switch to return to the RUN (16) position and let the
engine warm up to normal operating temperature.
11. Turn the temperature control (2) and the variable
speed fan control (1) all the way to the right to see if
the controls are operating correctly. Make sure the
variable speed fan control (1) operates in each of the
speed positions.
12. Turn the temperature control (2) all the way to the
left, the variable speed fan control (1) all the way to
the right and press the top half of the air conditioning
rocker switch (4) to engage the air conditioning.
MU6740
1
2
3
4
5
MU0650
6
7
8
11
10
9