Lull 944E-42 Service Manual - Manual (Page 830)

Transfer Carriage
11.28 Model 644E-42/944E-42 Rev. 6/04
13. Disconnect two hydraulic lines (1) connected to the
transfer cylinder (2). Plug, cap and label the hoses
and fittings.
14. Remove two bolts (3) securing the transfer cylinder
to the vehicle.
15. Lift, lower and place the transfer cylinder on support
blocks on a firm level surface.
b. Transfer Cylinder Installation
1. Lift the transfer cylinder into position on the vehicle
chassis.
2. Replace two bolts (3) securing the transfer cylinder
to the frame.
3. Connect two hydraulic lines (1) to the transfer
cylinder (2) according to their previously marked
positions.
4. Move the transfer carriage 5' 8'' (172 cm) so that the
pin (4) connecting the transfer cylinder to the
transfer carriage is at a pin access hole (5) near the
rear of the cab.
IMPORTANT: Make sure the threaded hole, of the
transfer cylinder pin, is facing downward during
installation.
5. Connect the transfer cylinder (6) to the transfer
carriage mount (7) with the transfer cylinder pin (8)
securing it with retaining rings (9).
6. If the vehicle has dual batteries, connect both
negative battery cables (10 and 11) to both
batteries.
Connect the lower negative battery cable (10) to the
negative (-) terminal on the lower battery (12). Swing
the upper battery box (13) in and make sure that the
lip (14) on the upper battery box slides below the
knob (15). Secure in place with the knob (15).
WARNING:
To avoid personal injury
and/or equipment damage, make sure the
cylinder is properly supported until it is
completely installed.
MU3370
1
2
3
MU3050
4
5
MU5490
9
6
7
8
9