Lull 944E-42 Service Manual - Manual (Page 807)

11.5 Model 644E-42/944E-42 Rev. 6/04
Transfer Carriage
12. Remove the boom as described in Section 3.3.3, a.
“Outer Boom Removal.”
13. Remove locknuts (10), washers (11), Lull logo
plate (12) and black backing (13) from the rear of the
vehicle (14).
14. Remove the bolts (15) and stop blocks (16) on both
sides.
15. Remove the two hydraulic hoses (17) connecting the
lift cylinder (18) to the hydraulic junction
manifold (19). Cap and label the hoses. Plug the
tube ports on the lift cylinder and the hydraulic
junction manifold.
16. Secure the lift cylinder with a sling and take up any
slack.
17. Remove the capscrew (20), washer (21) and pin (22)
from lift cylinder (18). Lower and place the cylinder
on support blocks on a firm level surface.
MU1630
10
11
12
13
14
MU1640
15
16
15
16
WARNING:
To avoid personal injury
and/or equipment damage, supporting the lift/
lower cylinder is essential when lifting and
reinstalling it back on the vehicle. Make sure
that the lift/lower cylinder is properly supported
until it is completely removed.
MU1691
17
18
19
20 21
22
17
17
17