Lull 944E-42 Service Manual - Manual (Page 238)

Engine: Cummins 4BT 3.9, B4.5T and QSB 4.5T
7.36 Model 644E-42/944E-42 Rev. 6/04
23. Remove hydraulic vent hoses (1, 2, and 3), and
secure them out of the way next to the firewall.
24. Remove the hydraulic oil return hose (4), capping
both ends, to prevent contaminants from entering
the system. Secure the hose out of the way next to
the firewall.
25. Disconnect the connector harness at the return oil
filter pressure switch (5).
26. Remove the hydraulic reservoir (6), sliding the tank
out from under the engine and away from the engine
mount frame (7).
27. Disconnect the transmission oil hoses (8) from the
reservoir retainer assembly (9) and from the
transmission (10). Cap the ends of each hose,
tubing and transmission hose fittings to prevent
contaminants from entering the system.
28. Remove the reservoir retainer assembly (11) by
removing two locknuts (12) and two flat washers
(13), that secure the retainer assembly to the engine
mount frame. Next remove two capscrews (14), and
two flat washers (15), that secure the reservoir
retainer to the battery tray (16). Remove the
reservoir retainer assembly.
29. Battery removal. Refer to Section 9.12.2, “Battery or
Batteries,” for removal procedures.
MU3000
1
2
3
4
5
MU3010
6
7
MU0940
8
9
10
MU3020
11
12
13
14
15
16