Lull 944E-42 Service Manual - Manual (Page 703)

9.193 Model 644E-42/944E-42 Rev. 6/04
Electrical System
11. With the ignition switch (28) in the RUN position (29)
press the front wiper switch (31) to the LOW (center)
position and then to the OFF position to “Park” the
front wiper motor on the left side of the windshield.
Turn the ignition switch back to the OFF
position (30).
12. Assemble the front wiper arm assembly (32) to the
wiper motor shaft (33) and the pivot shaft (34). The
wiper blade should be parallel with the left side of the
windshield.
13. Assemble the washers (35) and acorn nuts (36) to
the pivot shaft (34) and the motor shaft (33). Tighten
both securely.
14. Assemble the washer hose (37) onto the hose
connector on the wet kit adapter (38).
15. Lower and lock engine cover. To release and lower
the engine cover (39) from the fully raised position,
lift up slightly on the cover and push the upper part
of the right gas shock (40) (orange tab) to the left.
Line up the upper part of the shock lock tube with the
lower part of the gas shock and pull the cover down
to the closed position.
16. Turn ignition switch (28) to the RUN position (29),
and test the windshield wiper LOW speed and HIGH
speed functions. Turn the ignition switch to the
OFF (30) position.
17. If previously removed, install hydraulic hoses under
the dash. (Refer to Section 8.12.10, “Service Brake
Valve,” or Section 8.12.11, “Power Steering Valve.”)
MU0650
22
23
24
27
26
25
MU5910
31
28
29
30
37
38
36
35
34
33
32
35 MU6080
4110390
1.
2.
OU0780
39
40
40