Lull 944E-42 Service Manual - Manual (Page 118)

Cab and Covers
4.14 Model 644E-42/944E-42 Rev. 6/04
c. Service Brake Pedal Removal
1. Park the vehicle on a firm, level surface. Level the
vehicle, ground the attachment, place the travel
select lever in the (N) NEUTRAL DETENT position,
engage the parking brake switch and shut the
engine OFF.
2. Remove the lower dash panel (1).
3. Disconnect the brake return spring (2).
4. Remove the retaining clips (4) and slide brake pedal
shaft (3) out, toward the right side console (7), from
the pedal support and brake pedal assembly (6).
5. The service brake pedal (6) and shims (5) will fall
from the brake pedal support once the brake pedal
shaft (3) is removed.
6. Remove the bushings (8) from the brake pedal
tube (6).
d. Service Brake Pedal Installation
Note: The bushings (8) are a self-lubricating soft
material and should be inspected for reuse prior to
installation.
1. Install the bushings (8) into the ends of the brake
pedal tube (6).
2. Slide the shaft (3) through the brake pedal tube (6)
and install the shims (5) and retaining clips (4).
3. Reattach the brake return spring (2).
4. Adjust the brake switch as needed (refer to Section
9.14.19, c. “Stabilizer Brake Switch Adjustment.”)
5. Install and secure the lower dash panel (1). Secure in
place using four capscrews and flat washers. Torque
to 7 - 10 lb-ft (9,5 - 10,6 Nm).
MU3350
1
~
MU3450
2
4
5
3
6
7
8
8
5
4
5
~