Lull 944E-42 Service Manual - Manual (Page 694)

Electrical System
9.184 Model 644E-42/944E-42 Rev. 6/04
7. Rotate the suspect bulb holder assembly
(1 through 14) 1/4 turn counterclockwise.
8. Remove and replace bulb. All bulbs should be
replaced with a comparable OS 12V/1.2W bulb
except the alternator indicator (8). That bulb should
be replaced with a comparable OS 12V/3W bulb.
9. Place bulb holder assembly back into appropriate
space and rotate 1/4 turn clockwise.
10. Replace the dash panel rear access plate (15).
Secure with four phillips screws, (16).
11. Place the front dash panel (17) into the cut-out in the
cover (18), and secure in place using the two
nuts (19) and retaining brackets (20).
12. Connect the wire harness connector (21) at the rear
of the front dash panel (17).
13. Install the front dash panel cover (18), with the front
dash panel (17), to the dash in the cab. Secure in
place using five capscrews (22) and flat
washers (23). Torque to 25 - 36 lb-ft (3,5 - 5 Nm).
Item Description
1 Hydraulic Oil Filter Restriction
2 Low Brake Pressure
3 Engine Air Filter Restriction
4 Hydraulic Oil Temperature
5 Instrument Gauge Backlights
6 Transmission Temperature
7 Park Brake
8 Alternator
9 Engine Oil Pressure
10 Engine Air-Intake Heater
11 Stabil-TRAK™ Slow Pivot Mode
12 High Beam (Optional)
13 Stabil-TRAK™ Locked Mode
14 Turn Signal (Optional)
MU3460
1 2 3 4 5 6 7 8 9
10 11 12 13 14
MU3470
16
15
MU3440
22
23
18
17
21
19 20