Lull 944E-42 Service Manual - Manual (Page 819)

11.17 Model 644E-42/944E-42 Rev. 6/04
Transfer Carriage
11.3.11 Rear Roller Shimming
Note: The attachment should remain attached to the
quick attach.
1. Park the vehicle on firm level ground. Place the
travel select lever in the (N) NEUTRAL DETENT
position, engage the parking brake switch and raise
the boom to a horizontal (level) position.
2. Fully retract the boom and fully retract the transfer
carriage. Shut the vehicle OFF.
3. Lift the boom with a hoist to remove pressure off the
rear rollers. There should be a gap between the
rollers and the rails.
4. Move the transfer carriage so that the rear roller pin
can be removed through the hole in the side of the
frame.
5. Shut the engine OFF.
6. Place an Accident Prevention Tag on both the
ignition switch and steering wheel, stating that the
vehicle should not be operated. (Refer to Section
1.5, “Accident Prevention Tag Usage.”)
7. Open the engine compartment cover. Allow the
engine, transmission and hydraulic fluid to cool.
8. If the vehicle has dual batteries, disconnect both
negative battery cables (8 and 9) from both
batteries.
To access the lower battery (10), loosen the knob
(11) far enough so that the lip (12) on the upper
battery box clears the knob. Lift up the upper battery
box (13) and swing it out, so that the box clears the
hydraulic tank support bracket, to gain access to the
lower negative battery cable (8). Disconnect the
lower negative battery cable.
9. Remove locknuts (14), washers (15), Lull logo
plate (16) and black backing (17) from the rear of the
vehicle (18).
MU0650
8
9
10
11
12
13
MU1630
14
15
16
17
18