Lull 944E-42 Service Manual - Manual (Page 808)

Transfer Carriage
11.6 Model 644E-42/944E-42 Rev. 6/04
18. Remove the four hydraulic hoses (1) connecting the
slave cylinders (2) to the hydraulic tubes (3). Cap
and label the hoses.
19. Remove the capscrew (4) and mounting bracket (5).
Disconnect the hydraulic tubes (3) from the hydraulic
junction manifold (6). Plug the tube ports on the
slave cylinders and the hydraulic junction manifold.
20. Secure the slave cylinder with a sling and take up
any slack.
21. Remove the bolt (7) and locknut (8) from the pin (9).
Remove the pin from the slave cylinder (10). Lift,
lower and place the slave cylinder on support blocks
on a firm level surface.
22. Repeat steps 20 and 21 for the other slave cylinder.
MU1700
1
2
3
4
5
6
2
1
WARNING:
To avoid personal injury
and/or equipment damage, supporting the
slave cylinder is essential when lifting and
reinstalling it back on the vehicle. Make sure
that the slave cylinder is supported until it is
completely removed.
MU1910
7
8
9
10