Lull 944E-42 Service Manual - Manual (Page 153)

5.7 Model 644E-42/944E-42 Rev. 6/04
Axles, Drive Shafts, Wheels, Tires and Brakes
Note: The axle will oscillate freely when the cylinder
mounting pin is removed.
12. Remove the capscrew (11) and elastic locknut (12)
securing the lower position cylinder mount pin (13) to
the cylinder (14). Tap the cylinder mount pin out, and
move the cylinder to prevent it from interfering with
axle removal.
Note: Remove the capscrews at equal intervals to avoid
binding.
13. Remove the four capscrews (15) four elastic locknuts
(16), and eight hardened washers (17) securing the
front (18) or rear (19) axle supports (rotating
trunnions) to the vehicle frame.
14. Remove the axle (20-Front or 21-Rear), from the
vehicle using the jack, hoist or overhead crane and
sling supporting the axle. DO NOT raise or otherwise
disturb the vehicle while removing the axle. Balance
the axle and prevent it from tipping, turning or falling
while removing it from beneath the vehicle. Place the
axle on a suitable support or holding stand.
15. If the axle is being replaced with a new axle, remove
and cap all hydraulic hoses and fittings from the axle
and mark their location.
MU0610
9
10
11
12
13
14
15
16
17
18
12
11
16
17
17
19
13
17
15
14
20
21