Lull 944E-42 Service Manual - Manual (Page 246)

Engine: Cummins 4BT 3.9, B4.5T and QSB 4.5T
7.44 Model 644E-42/944E-42 Rev. 6/04
26. Position the air cleaner hose over the turbocharger
intake opening. Install the air cleaner, aligning the
mounting band with the firewall, sliding the hex
bolts (3) into the slots. Torque mounting hex bolts to
11-19 lb-ft (15-25 Nm). Torque the air cleaner hose
clamp (1) to 75 lb-in (8,8 Nm). Reconnect air intake
sensor (2).
27. Refer to Section 8.11.2, “Pump Replacement,” for
installation procedures.
Note: ALWAYS replace elastic locknuts with new elastic
locknuts to help ensure proper fastening.
28. Install three buttonhead capscrews (4) and three
elastic locknuts (5) securing the battery tray(s) (6) to
the engine mount frame. Torque capscrews to
13-22 lb-ft (17-31 Nm).
29. Battery installation. Refer to Section 9.12.2, “Battery
or Batteries,” for installation procedures.
30. Install the reservoir retainer assembly (7) by first
placing the left side of the assembly onto the
threaded studs (8) protruding from the engine mount
frame. Next align the align the right side of the
assembly with the holes located on the top of the
battery tray (9). Secure the left side using two flat
washers (10) and two locknuts (11). Torque to
37-66 lb-ft (50-90 Nm). Secure the right side of the
assembly to the battery tray using two flat
washers (12), and two capscrews (13). Torque to
21-38 lb-ft (29-52 Nm).
MU1770
1
2
3
MU3030
4
5
6
MU3020
7
8
9
10
11
12
13