Lull 944E-42 Service Manual - Manual (Page 810)

Transfer Carriage
11.8 Model 644E-42/944E-42 Rev. 6/04
28. Remove capscrews (1), shims (2), and rear wear
pads (3). Count and label their position for later
replacement.
29. Remove capscrews (4), shims (5), and front wear
pads (6). Count and label their position for later
replacement.
30. Remove capscrew (7), washer (8), spacer (9) and
locknut (10) from roller pin (11) and transfer
carriage (12).
31. Remove front roller pin (11), front roller (13) and
shims (14) from both sides of the transfer carriage.
Count and label their positions for later replacement.
32. Remove lifting straps, boom pivot pins and slave
cylinder pins.
33. Inspect transfer carriage cylinder mount, boom pivot
and slave pivot bushings. (Refer to Section 11.3.17,
“Boom Pivot Bushing Replacement.”)
34. Inspect front and rear roller bushings. (Refer to
Section 11.3.17, “Boom Pivot Bushing
Replacement.”)
35. Inspect front rollers. (Refer to Section 11.3.15, “Front
Roller and Bushing Replacement.”)
36. Inspect rear rollers. (Refer to Section 11.3.16, “Rear
Roller and Bushing Replacement.”)
37. Inspect front wear pads. (Refer to Section 11.3.6,
“Front Upstop Wear Pad Check.”)
38. Inspect rear wear pads. (Refer to Section 11.3.3,
“Rear Wear Pad Check.”)
MU1780
1
2
3
MU1800
4
5
6
MU1790
7
8
9
10
11
12
13
14