Lull 944E-42 Service Manual - Manual (Page 43)

2.27 Model 644E-42/944E-42 Rev. 6/04
General Information, Specifications and Maintenance
2.6.10 Paint
Unless otherwise specified, paint components, as
indicated, in the following sections.
a. Orange Paint
Durable, premium Lull orange paint is available in both a
convenient 16-ounce (480 ml) spray can for touch-ups,
and in a production-sized one gallon (3,8 liters) container
for extensive repainting. Consult the appropriate parts
manual for the applicable part number and ordering
information. Use orange paint on all vehicle components
except as specified in paragraph 2.6.10, b.
b. Black Paint
Durable, premium black paint is available in both a
convenient 16-ounce (480 ml) spray can for touch-ups,
and in a production-sized one gallon (3,8 liters) container
for extensive repainting. Consult the appropriate parts
manual for the applicable part number and ordering
information.
• Axles
• Drive Shafts
• Transfer Case
• Quick Attach
• Carriage
• Forks
• Mirrors and Mirror Brackets
• Cylinders
• Wheels
• Engine Mount
• Fuel Tank Support-Top
• Cab Floor Plate
• Engine Support Structure and Skirt
• Cab Mount
• Valve Plate
• Cab Step
• Rear Frame Backing Plate
• Counterweight (944E Only)
2.6.11 Thread Locking Compound
For general thread-locking purposes, Loctite ® products,
manufactured by Loctite Corporation, are recommended.
Contact:
Loctite Corporation
1001 Trout Brook Crossing
Rocky Hill, CT 06067 USA
Phone: 1-800-LOCTITE (1-800-562-8483)
FAX: (860) 571-2460
Internet: http://www.loctite.com
Loctite
®
is a registered trademark of Loctite Corporation.
2.7 CLEANING
Dirt and abrasive dust reduce the efficient working life of
parts and systems, and lead to the costly replacement of
components. To help increase the service life of parts,
clean the exterior of all parts before beginning any repairs.
Use cleaning fluids and solvents suitable for cleaning
parts that do not create safety hazards. Certain types of
cleaning fluids can cause skin irritation and damage to
components (such as rubber, electrical parts, etc.).
Servicing the hydraulic system in particular requires
cleanliness.
Follow these precautions before attempting to service
any hydraulic component:
1. Flush hose and tube assemblies with a solvent
compatible with hose materials. Blow excess solvent
away with shop air.
2. Cap hydraulic fittings, hoses and tube assemblies,
and protect threads until time of installation. Clean
up any hydraulic fluid spillage immediately.
3. Flush hydraulic reservoir, fuel tank, and gear
housing with a suitable solvent to remove paint,
metal chips, etc.
4. Protect hydraulic system components from airborne
contaminants. Plug all cylinder, valve, reservoir, tank
and pump openings until time of installation.
5. Use clean, filtered oil when filling the system.
Maintain the hydraulic system at a minimum cleanliness
level of ISO code 18/15-particle ration count.