10 parameter reference – Lenze 8400 BaseLine C User Manual
Page 236
10
Parameter reference
10.2
Parameter list
236
Lenze · 8400 BaseLine C · Reference manual · DMS 1.6 EN · 01/2014 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00002/13
0: Off / ready
Reserved
C00002/14
0: Off / ready
Reserved
C00002/15
0: Off / ready
Reserved
C00002/16
1: On / start
Enable controller
"1" ≡ Enable controller
"0" ≡ Inhibit controller
C00002/17
0: Off / ready
Activate quick stop
"1" ≡ Activate quick stop
"0" ≡ Deactivate quick stop
C00002/18
0: Off / ready
Reserved
C00002/19
0: Off / ready
Reset error
• After resetting the current error, further errors may be
pending which must be reset as well.
• Details of the currently pending error are displayed in
.
C00002/20
0: Off / ready
Reserved
C00002/21
0: Off / ready
Delete logbook
• All entries in the controller logbook will be deleted.
• In the logbook, information on the error history is sa-
ved.
C00002/22
0: Off / ready
Reserved
C00002/23
0: Off / ready
Identify motor parameters
• This device command serves to carry out an auto-
matic identification of the motor parameters.
• The device command is only executed when the con-
troller is in the "SwitchedOn" state.
• In order to identify the motor parameters, the cont-
roller must be enabled after this device command.
Identifying motor parameters automatically
C00002/24
0: Off / ready
Reserved
C00002/25
0: Off / ready
Reserved
C00002/26
0: Off / ready
CAN reset node
• Reinitialise "CAN on board" interface.
• Required when changing the baud rate, node address,
or identifiers.
C00002/27
0: Off / ready
Reserved
C00002/28
0: Off / ready
Reserved
C00002/29
0: Off / ready
Reserved
C00002/30
0: Off / ready
Reserved
C00002/31
0: Off / ready
Reserved
C00002/32
0: Off / ready
Reserved
Read access Write access CINH PLC STOP No transfer COM MOT
Scaling factor: 1
Parameter | Name:
C00002 | Device commands
Data type: UNSIGNED_8
Index: 24573
d
= 5FFD
h