Lenze 8400 BaseLine C - Manual (Page 52)

4 Device control (DCTRL)
4.1 Device commands
52
Lenze · 8400 BaseLine C · Reference manual · DMS 1.6 EN · 01/2014 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
4.1.10 CAN reset node
The C002/26 = "1: On / start" device command reinitialises the CAN interface which is required after
e.g. changing the data transfer rate, the node address, or identifiers..

General information on the CAN interface can be found in the chapter entitled " System
bus "CAN on board" ". ( 169)