Lenze 8400 BaseLine C - Manual (Page 44)

4 Device control (DCTRL)
44
Lenze · 8400 BaseLine C · Reference manual · DMS 1.6 EN · 01/2014 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
4 Device control (DCTRL)
This chapter provides information on the internal device control as well as the device commands
which can be executed via the subcodes of C002 .
• The device control causes the controller to take defined device states.
• The device control provides a multitude of status information in many ways:
• Optically via the LED status display of the integrated keypad. ( 18)
• As text messages in the Logbook . ( 149)
• As process signals via the outputs of the LS_DriveInterface system block. ( 325)
• Via diagnostic / display parameters which are included in the »Engineer« parameter list as
well as in the Diagnostics category in the keypad.

Note!
The device states of the controller are based on the operating states of the CiA402 stan-
dard.  Device states ( 53)